How to Tweak the Mount Kit for Proper Belt Tracking

To check proper belt tracking, remove Safety Cover, roll bike slowly – belt should track down the center of the gear – should Not push hard/constantly on either side.

IF the belt running tight on either side of the drive gear, indicates the mount is not properly aligned – standing at rear of bike:

1. The front of the engine mount bracket is pointed to the right or left – loosen both engine mount nuts, push front of the engine to the left. Roll bike forward and watch the belt, you can move the belt tracking by moving the front of the engine to the left or right. Note – moving the front of the engine/mount to the left makes the belt track to the left/outside. Moving it to the right, makes it track to the right/engine side. Tighten nuts when tracking is straight.
IF the belt still does not track down the center, there is another adjustment you can make:
2. Loosen axle nuts, raise right or left side of strap* slightly, torque nuts securely when adjustment complete.

*Raising the strap on the engine side will make the belt run to the left (opposite), lowering the strap on the engine side, makes the belt track to the right or toward the engine. The left side of the strap has the same (but opposite) effect.