Illustration of Corner Brake Lamp
|
Battery installation
- Press down with thumb on the protruding line
of the cell and push open.
- Install two "AA" 1.5V batteries
inside in the correct direction, then close
cell.
Corner lamp installation
- First encase clamp on the top of saddle tube,
then tighten up the screw till suitable.
Set the bend buckle in the sink on the stand
of corner lamp and tighten up till suitable.
- Install the control switch on the handle,
close the rubber collar of handle in case
turn the switch freely; then truss up the
corner lamp with thread in the control switch
box around trestle.
|
|
 |
How to install the brake
cable sensor switch:
** In general the Switch
should be installed
into a stripped brake cable
wire near to
the rear brake.
- For the center-pull (fig. a) and cantilever
brakes (fig. b), install the switch as shown.
Function Instructions:
- "NIGHT" refers to the night lamp.
Push the switch to the position "ON",
the middle light of the rear lamp will be
turned on.
- "DIRECTIONAL" refers to the direction
lamp. Push the switch to the position "L",
the left direction light will be turned on;
push the switch to the position "R",
the right direction light will be turned
on.
- "
 " refers to the horn button. Adjust
the switch position on the controlling handle,
you can choose eight different tones.
Mount on Safety Cover or
Fender:
- Remove back bend buckle, install on L bracket
(supplied) with lock
nut (supplied) adjust
and Tighten Securely.
- Drill 1/4 hole in fender/cover, insert threaded
pin, secure w/2nd lock
nut and Tighten.
|
|
